About this tool
The tree profile with a radiused end takes the sharp corner out of the picture, which matters when cleaning up a slot or opening out a drilled hole. It reaches where a cylinder cannot and does not dig in when you tilt it.
Where it works
Slot dressing, opening out drilled holes, and deburring where access is angled.
Cutting data — starting point
Starting values for a rigid setup with a good coolant supply. Treat them as a first trial, then adjust to the machine, the holder and the actual condition of the material.
| Work material | Cutting speed vc | Feed | Depth of cut |
|---|---|---|---|
| Steel / stainless (P/M) | 15,000–25,000 rpm | Hand feed | Light, steady pressure |
| Cast iron (K) | 15,000–25,000 rpm | Hand feed | Light, steady pressure |
What you can specify
- Diameter, corner radius and flute count ground to your drawing
- Coating — AlCrN, AlTiN, TiAlN, DLC or uncoated, matched to the workpiece
- Shank — h6 ground, HA / HB / whistle-notch
- Laser-marked part number, or blank shanks for distributor stock
Not sure about the geometry? Send the drawing or a photo of the part. We recommend the profile, the coating and the starting cutting data — and quote from there.
