2-Flute Ball Nose End Mill — Long Reach
A long, slender ball nose for deep cavities and radii that sit well below the surface line, with a tapered…
Ø1–12 mm (R0.5–6) · 2 · AlCrN
Ball Nose End Mills
Ball geometry for 3D contouring, mold and die work, and radii that have to blend cleanly. Long-reach and tapered versions for deep cavities.
2-Flute Ball Nose End Mill — Standard
The standard-length ball nose: the everyday tool for 3D surfacing, radius blending and finishing in a rigid setup.
Ø1–20 mm · 2 · AlCrN
4-Flute Ball Nose End Mill — Hardened Steel
Four flutes for high-feed finishing in hardened tool steel, with an AlTiN coating that survives the heat.
Ø3–16 mm · 4 · AlTiN
Tapered Ball Nose End Mill — Mold Finishing
A half-degree taper lets one tool finish drafts, fillets and deep ribs that would otherwise need three setups.
Ø1–8 mm, taper 0.5°–3° · 2 · AlCrN
Ball Nose End Mill — Deep Cavity, 4-Flute
Neck relief and a four-flute core for cavities deeper than three diameters, where chip evacuation and stiffness both matter.
Ø2–12 mm · 4 · AlTiN
Can't find the geometry you need?
Most of what we ship is ground to a drawing. Send yours — we quote within 24 hours.