Aluminum – Conko Metal Technology

20 entries Ask about a specific tool

The everyday carbide drill for holes up to three diameters deep. Faster than HSS, and it holds size.

A long, slender ball nose for deep cavities and radii that sit well below the surface line, with a tapered neck for rigidity.

The standard-length ball nose: the everyday tool for 3D surfacing, radius blending and finishing in a rigid setup.

A half-degree taper lets one tool finish drafts, fillets and deep ribs that would otherwise need three setups.

High-helix three-flute geometry with a radiused corner for aluminium, where chip clearance decides the finish.

Ground carbide down to Ø0.2 mm for features a standard tool cannot reach, with runout held tight enough to matter.

Micro ball geometry for small 3D surfaces, radii and ribs where the finish has to come off the tool, not the polisher.

The micro tool that stops chipping: a small radius on a small edge makes a disproportionate difference to tool life.

Diamond-like carbon on a micro edge: the coating that stops aluminium sticking where you cannot afford to stop and clean the tool.

Polished three-flute geometry with a high helix, built for aluminium and non-ferrous work at high spindle speeds.

Can't find the geometry you need?

Most of what we ship is ground to a drawing. Send yours — we quote within 24 hours.